Editing Solderless protoboard
Jump to navigation
Jump to search
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone. Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 71: | Line 71: | ||
[[Image:notextendedw.png|alt text]] and put together >> [[Image:Extendedw.png|alt text]] | [[Image:notextendedw.png|alt text]] and put together >> [[Image:Extendedw.png|alt text]] | ||
− | *Expanding on the "double ended" header above. | + | *Expanding on the "double ended" header above. Right angle headers are long enough to bend the pins so they are long on both sides. Take a dual row one and bend the pins to fit across the gap at the center of the proto board. Then you can plug in a dual plug like those on hard drive cables. Pictures comming in a bit. |
− | Right angle headers are long enough to bend the pins so they are long on both sides. Take a dual row one and bend the pins to fit across the gap at the center of the proto board. Then you can plug in a dual plug like those on hard drive cables. Pictures | ||
[[Image:rightanglew.png|alt text]] and bending it a bit >> [[Image:bentw.png|alt text]] | [[Image:rightanglew.png|alt text]] and bending it a bit >> [[Image:bentw.png|alt text]] |