Difference between revisions of "Optoelectronics"

From OpenCircuits
Jump to navigation Jump to search
Line 18: Line 18:
# [http://en.wikipedia.org/wiki/Light_Emitting_Diode Light-emitting diode From Wikipedia, the free encyclopedia]
# [http://en.wikipedia.org/wiki/Light_Emitting_Diode Light-emitting diode From Wikipedia, the free encyclopedia]
# [http://www.iguanalabs.com/1stled.htm Learning About Transistors and LEDs]
# [http://www.iguanalabs.com/1stled.htm Learning About Transistors and LEDs]
# [http://www.piclist.com/techref/io/led/pulse.htm?key=base+resistor&from= Brighter Appearance through pulsing]
== LCDs ==
== LCDs ==

Revision as of 08:10, 30 January 2008

Optoelectronics are devices that are some combination of electrical and optical. Perhaps the simplest is the Light Emitting Diode or LED which converts electrical energy into light. A listing of some optoelectronic devices follows.


LEDs are diodes designed to produce visible light.

Commonly a small low power device that makes a not too bright light. High power, high brightness versions are now becoming widely available. The low power ones typically run on a volt or so, at about 10 ma. Typically they are run on higher voltages with a current limiting resistor that sets the current. Current control is almost always required ( often with a resistor ) as LED are very sensitive to small voltage changes. Like other diodes they conduct only in one direction.

When using a LED in a cicuit it's important to use a current limiter such as a resistor. When using resistors measure the foreward voltage drop of the LED with a multimeter, subtract this from the supply voltage, then plug the difference into ohms law to calculate the required resistor value. Different color LEDs all have different voltage drops.


  • Indicator
  • Part of 7 segment display
  • Light source

External Links

  1. Light-emitting diode From Wikipedia, the free encyclopedia
  2. Learning About Transistors and LEDs
  3. Brighter Appearance through pulsing


Liquid Crystal Displays

  • Serial - These displays have a microcontroller on the display with a serial or I2C connection. Several builtin fonts are typically included. These displays are very easy to use, but the update rate for a display is very slow. Fullblown bitmap support is usually not available. Typical price for these displays is $50+.
  • Parallel - Parallel displays connect to a microcontroller via a parallel interface( the bitwidth varies from 8bits to 32bits ). Displays can have a much faster update rate then serial since they allow arbitrary graphs to be display. The displays are typically much cheaper then serial display starting as low as $20.

Finding LCD displays is not easy since huge distributors such as Digikey have a limited selection.

Some places that do have LCDs for hobby use:

  • Sparkfun - Has a good selection of both parallel and serial displays.
  • MatrixOrbitral - Specializes in serial display especially the type for direct connection to a PC.
  • Jameco - A small selection. Mostly serial.

Photo Diode

Photo Transistor

Photo Multiplier

Solid State Laser

Optical Isolator

Photo Resistor

Photovoltaic Cell

  1. Photovoltaics - Wikipedia, the free encyclopedia