Editing GreenHouse Monitor Program
Jump to navigation
Jump to search
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone. Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 3: | Line 3: | ||
− | This is | + | This is an arduino program intended to monitor the environment in a green house and its PC side written in Python. The Arduino has a simple command driven interface. It is designed to run with [[Python Smart Terminal]] Documentation on the construction of a Smart Terminal extension to support the green house monitor and save its data to a csv file are also part of this project and the documentation here. Another adaptation for the SmartTerminal is described in [[SmartTerminal for Controlino]] |
Note that since this was written the SmartTerminal has been updated and its operation and parameter set up have been upgraded and in some ways simplified. I will be updating this documentation ( hopefully soon Feb 2018 -- did not hapen ). Another update the python side of the Green House Monitor used to be ext_process_gh.py but has now been absorbed into ( and is a mode ) in ext_process_env_monitor.py. This documentation will perhaps be revised at some point to reflect that change. | Note that since this was written the SmartTerminal has been updated and its operation and parameter set up have been upgraded and in some ways simplified. I will be updating this documentation ( hopefully soon Feb 2018 -- did not hapen ). Another update the python side of the Green House Monitor used to be ext_process_gh.py but has now been absorbed into ( and is a mode ) in ext_process_env_monitor.py. This documentation will perhaps be revised at some point to reflect that change. |