Difference between revisions of "FreeCad .17 Examples"
Jump to navigation
Jump to search
Russ hensel (talk | contribs) (Created page with "== Introduction == *FreeCad: Using Example Models *FreeCad .17 Example PartDesignPrimitives Category:FreeCad") |
Russ hensel (talk | contribs) |
||
| (2 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
== Introduction == | == Introduction == | ||
| + | |||
| + | This is a useless page, soon to be deleted. | ||
*[[FreeCad: Using Example Models]] | *[[FreeCad: Using Example Models]] | ||
| Line 7: | Line 9: | ||
*[[FreeCad .17 Example PartDesignPrimitives]] | *[[FreeCad .17 Example PartDesignPrimitives]] | ||
| + | |||
| + | * D:\Russ\0000\FreeCad\Point17\HoleInCyl_1.FCStd use part design with a cylinder from part, map to top face, hole moves with the cyl. | ||
| + | * D:\Russ\0000\FreeCad\Point17\HoleInCyl_2.FCStd same as HoleInCyl_1 but done in freecad .16 open in .17 and compare to HoleInCyl_1 | ||
[[Category:FreeCad]] | [[Category:FreeCad]] | ||
Latest revision as of 11:20, 12 December 2019
Introduction[edit]
This is a useless page, soon to be deleted.
- D:\Russ\0000\FreeCad\Point17\HoleInCyl_1.FCStd use part design with a cylinder from part, map to top face, hole moves with the cyl.
- D:\Russ\0000\FreeCad\Point17\HoleInCyl_2.FCStd same as HoleInCyl_1 but done in freecad .16 open in .17 and compare to HoleInCyl_1
