Difference between revisions of "FreeCad .17 Examples"
Jump to navigation
Jump to search
Russ hensel (talk | contribs) |
Russ hensel (talk | contribs) |
||
| (One intermediate revision by the same user not shown) | |||
| Line 1: | Line 1: | ||
== Introduction == | == Introduction == | ||
| + | |||
| + | This is a useless page, soon to be deleted. | ||
*[[FreeCad: Using Example Models]] | *[[FreeCad: Using Example Models]] | ||
| Line 8: | Line 10: | ||
| − | D:\Russ\0000\FreeCad\Point17\HoleInCyl_1.FCStd use part design with a cylinder from part, map to top face, hole moves with the cyl. | + | * D:\Russ\0000\FreeCad\Point17\HoleInCyl_1.FCStd use part design with a cylinder from part, map to top face, hole moves with the cyl. |
| − | + | * D:\Russ\0000\FreeCad\Point17\HoleInCyl_2.FCStd same as HoleInCyl_1 but done in freecad .16 open in .17 and compare to HoleInCyl_1 | |
[[Category:FreeCad]] | [[Category:FreeCad]] | ||
Latest revision as of 11:20, 12 December 2019
Introduction[edit]
This is a useless page, soon to be deleted.
- D:\Russ\0000\FreeCad\Point17\HoleInCyl_1.FCStd use part design with a cylinder from part, map to top face, hole moves with the cyl.
- D:\Russ\0000\FreeCad\Point17\HoleInCyl_2.FCStd same as HoleInCyl_1 but done in freecad .16 open in .17 and compare to HoleInCyl_1
