Difference between revisions of "Manhattan style"
(brief summary) |
|||
| Line 1: | Line 1: | ||
| + | '''Manhattan style''' | ||
| + | is one popular way to build ham radio electronics. | ||
| + | It involves small "pads", typically circular dots roughly 3 mm diameter punched out of plain copper-clad board. | ||
| + | |||
| + | The pads are super-glued onto the "substrate", a large copper-clad board. | ||
| + | Each component is mounted right-side-up by soldering its pins to pads. | ||
| + | |||
| + | The builders try to make each pad represent one node in the schematic -- every pin that connects to that node is soldered to one pad, when possible. | ||
| + | When it's not possible, hook-up wire is used to connect pad-to-pad and pad-to-DIP-socket-pin. | ||
| + | |||
| + | Each ground pin of a component is soldered directly to the substrate. | ||
| + | |||
| + | K7QO has an excellent description of the technique: | ||
http://www.k7qo.net/manhattan.pdf | http://www.k7qo.net/manhattan.pdf | ||
| + | |||
| + | ''(FIXME: put a photograph here)'' | ||
| + | |||
| + | ---- | ||
Revision as of 07:39, 12 June 2007
Manhattan style is one popular way to build ham radio electronics. It involves small "pads", typically circular dots roughly 3 mm diameter punched out of plain copper-clad board.
The pads are super-glued onto the "substrate", a large copper-clad board. Each component is mounted right-side-up by soldering its pins to pads.
The builders try to make each pad represent one node in the schematic -- every pin that connects to that node is soldered to one pad, when possible. When it's not possible, hook-up wire is used to connect pad-to-pad and pad-to-DIP-socket-pin.
Each ground pin of a component is soldered directly to the substrate.
K7QO has an excellent description of the technique: http://www.k7qo.net/manhattan.pdf
(FIXME: put a photograph here)
